Checking The Oil Level - Husqvarna TE 250 2008-I.E. Merkmale, Gebrauch, Wartung

Cap5_GB 9-07-2007 16:25

CHECKING THE OIL LEVEL

Keeping the motorbike level and in a vertical position, check the
oil level through the inspection (1) window on the right
crankcase. Make sure the level is in between the MIN and MAX
notches.
To fill up, remove the filler cap (2).
Note*: Have this operation made with
warmed-up engine.
WARNING*: Be careful not to touch hot en-
gine oil.
1
2
Pagina 31
ENGINE OIL REPLACEMENT AND BAG FILTERS-FIL-
TER CARTRIDGE CLEANING OR REPLACEMENT
WARNING*: Be careful not to touch hot en-
gine oil.
Drain the oil with WARM ENGINE; proceed as follows:
- remove oil filler cap (1);
- remove the engine guard (A)
- place an oil drain pan under the engine block
- remove the oil drain cap (2)
- drain the used oil completely then clean the magneto on the
cap;
MAX
MIN
2
3
- remove the three filters (4), (5) and (6) on the L.H. side of
the engine, check O-Rings for wear then clean filters with fu-
el; reassemble using the reverse procedure;
- in order to replace the filter cartridge (3), unscrew the three
fastening screws then the filter cartridge cover;
- after filters replacement, reassemble the drain cap (2), the
engine guard (A) then pour the recommended oil quantity.
A
A
4
31