Installation Instructions; Tire Clearance - SR Suntour AIR SPRING SERIE Bedienungsanleitung

SR SUNTOUR - OWNERS MANUAL

INSTALLATION INSTRUCTIONS

Note! All fixing bolts have to be tightened with the proper fasting torque stated by the
manufacturers
1. Remove the existing fork from your bicycle. Afterwards remove the crown race from the
fork.
2. Measure the length of your old fork's steerer tube against the length of the SR SUNTOUR
fork steerer. SR SUNTOUR suspension forks are delivered with a standard steerer tube
length of 255mm. Therefore the steerer tube may need cutting to the proper length.
3. In order to define the proper length of your steerer tube you can apply the
following formula:
Frame's head tube+Head sets stack height+Spacers+Stem's clamp height-
If your SR SUNTOUR fork does come with a threadless steerer tube, do not add a
thread to it. SR SUNTOUR'S fork steeres are a one time press fit which can not be
removed. Do not try to replace the steerer tube by a steerer tube with a threaded
steerer. This will void the warranty of your fork and result into a failure of the
4. Install the headset crown race (30mm for 1 1/8") firmly against the top of your fork
crown. Install the fork unit (headset,spacers,stem) back on the bike. Adjust the headset
until you do not feel play anymore. Also refer to the headset's manufacturer installation
instructions.
5. Install the brakes according to the manufacturer's instructions. Make sure to adjust the
brake pads properly. If you use a disc brake, only mount your brake to the original disc
brake mounting holes. Only use cantilever brakes which are intended to be used with
a hangerless brace. Check the installation instructions of your brake manufacturer and
follow them. Make sure you choose the correct length of the brake cable in order to not
interfere the performance of the fork.
6. Re-install the wheel back on to your bike. If you are using a
fasten your wheel set, make sure that all fasteners and nuts are adjusted properly (four
or more threads have to be engaged in the nut when it is closed) In case your fork comes
with a through axle system, make sure that all fixing bolts are tightened with the
appropriate torque values. Please also refer to the Qloc section of this manual.

TIRE CLEARANCE !

Your SR SUNTOUR suspension fork is designed to be used with 26" tires. Each tire has a
different outer diameter (tire width and height). Therefore the clearance between your tire
and fork needs to be checked, to make sure your tire does not get in contact with any
part of your fork. Keep in mind that the narrowest part of your fork is located at the brake
bosses. If you want to remove your wheel, you might have to deflate your tire, in order to
be able to pass it through your brake bosses.
6
English
product or could cause fatal injuries or even death to the rider.
AXON / EPICON / RAIDON air
Warning!
3mm clearance
quick release system to