Installation Instructions; Tire Clearance - SR Suntour SWING SHOCK Benutzerhandbuch

SR SUNTOUR OWNERS MANUAL

INSTALLATION INSTRUCTIONS

Note! All fixing bolts have to be tightened with the proper fastening torque stated by the
manufacturers
1. Remove the existing fork from your bicycle. Afterwards remove the crown race from the
fork.
2. Measure the length of your old fork's steerer tube against the length of the SR SUNTOUR fork
steerer. SR SUNTOUR suspension forks are delivered with a standard steerer tube length of
255mm. Therefore the steerer tube may need cutting to the proper length.
3. In order to define the proper length of your steerer tube you can apply the
following formula:
Frame's head tube + Head sets stack height+Spacers + Stem's clamp height -
If your SR SUNTOUR fork does come with a threadless steerer tube, do not add a
thread to it. SR SUNTOUR'S fork steeres are a one time press fit which cannot be
removed. Do not try to replace the steerer tube by a steerer tube with a threaded
steerer. This will void the warranty of your fork and result into a failure of the product
Please also note that the coil spring of your swing shock fork is located in the steerer
4. Install the headset crown race (30mm for 1 1/8") firmly against the top of your fork crown.
Install the fork unit (headset,spacers,stem) back on the bike. Adjust the headset until you do
not feel play anymore. Also refer to the headset's manufacturer installation instructions.
5. Install the brakes according to the manufacturer's instructions. Make sure to adjust the
brake pads properly. If you use a disc brake, only mount your brake to the original disc
brake mounting holes. Only use cantilever brakes which are intended to be used with a
hangerless brace. Check the installation instructions of your brake manufacturer and follow
them. Make sure you choose the correct length of the brake cable in order to not interfere
with the performance of the fork.
6. Reinstall the wheel back on to your bike. If you are using a
your wheel set, make sure that all fasteners and nuts are adjusted properly (four or more
threads have to be engaged in the nut when it is closed) In case your fork comes with a
through axle system, make sure that all fixing bolts are tightened with the appropriate torque
values.

TIRE CLEARANCE !

Your SR SUNTOUR suspension fork is designed to be used with 28"/700C tires. Each tire
has a different outer diameter (tire width and height).Therefore the clearance between
your tire and fork needs to be checked, to make sure your tire does not get in contact with
any part of your fork. Keep in mind that the narrowest part of your fork is located at the
brake bosses. If you want to remove your wheel, you might have to deflate your tire, in
order to be able to pass it through your brake bosses.
Note! Using a tire which exceeds the maximum tire size suitable to your fork is very
dangerous and could cause an accident, fatal injuries or even death to the rider
or could cause fatal injuries or even death to the rider.
tube. Do never cut the steerer shorter than 90mm!
Warning!
quick release system to fasten
SWING SHOCK
3mm clearance
English
5