Herunterladen Inhalt Inhalt Diese Seite drucken

Fork Installation; Installation Instructions - SR Suntour nrx Benutzerhandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

SR SUNTOUR - OWNERS MANUAL

FORK INSTALLATION

WARNING!
SR SUNTOUR strongly recommends that your fork is being installed by a trained and qualified
bicycle mechanic. Special knowledge and tools are essential to install SR SUNTOUR forks.
Common mechanical knowledge may not be sufficient to install a SR SUNTOUR suspension
fork. If you intend to install the fork by yourself, the whole job has to be inspected by a
trained and qualified bicycle mechanic. Please note, that improperly installed forks are
extremely dangerous and can cause damage to the product, serious injuries or even death.

INSTALLATION INSTRUCTIONS

Note!
All fixing bolts have to be tightened with the proper fasting torque stated by the
manufacturers
1.
Remove the existing fork from your bicycle. Afterwards remove the crown race from the
fork.
2.
Measure the length of your old fork's steerer tube against the length of the SR SUNTOUR
fork steerer. SR SUNTOUR suspension forks are delivered with a standard steerer tube
length of 255mm. Therefore the steerer tube may need cutting to the proper length.
3.
In order to define the proper length of your steerer tube you can apply the
following formula:
Frame's head tube+Head sets stack height+Spacers+Stem's clamp height-
If your SR SUNTOUR fork does come with a threadless steerer tube, do not add a
thread to it. SR SUNTOUR'S fork steeres are a one time press fit which can not be
removed. Do not try to replace the steerer tube by a steerer tube with a threaded
steerer. This will void the warranty of your fork and result into a failure of the
4.
Install the headset crown race (30mm for 1 1/8") firmly against the top of your fork
crown. Install the fork unit (headset,spacers,stem) back on the bike. Adjust the headset
until you do not feel play anymore. Also refer to the headset's manufacturer installation
instructions.
5.
Install the brakes according to the manufacturer's instructions. Make sure to adjust the
brake pads properly. If you use a disc brake, only mount your brake to the original disc
brake mounting holes. Only use cantilever brakes which are intended to be used with
a hangerless brace. Check the installation instructions of your brake manufacturer and
follow them. Make sure you choose the correct length of the brake cable in order to not
interfere the performance of the fork.
6.
Re-install the wheel back on to your bike. If you are using a
fasten your wheel set, make sure that all fasteners and nuts are adjusted properly (four
or more threads have to be engaged in the nut when it is closed) In case your fork comes
6
with a through axle system, make sure that all fixing bolts are tightened with the
appropriate torque values.
English
product or could cause fatal injuries or even death to the rider.
NRX / NCX LITE / NCX / CR9
Warning!
3mm clearance
quick release system to

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ncx liteNcx iiNcxCr9v

Inhaltsverzeichnis