Control Panel And Functions - Jacuzzi andros Montageanweisung, Bedienung Und Wartung

i
8
Perform the same steps to insert the other two numbers.
Once you have inserted the password, the display will show
the message I1x (parameter for temperature unit of measure.
Press the "Light" key again to go to parameter I2x ("x" may
vary within the range of 10 to 32 amps at 2 amp intervals; the
0 value does not include the power absorption regulated by
the energy limiter; the stored factory setting is 32).
Use the "Up" and/or "Down"
and then confirm the selection with the "Light"
Press the "Light" key again to exit the procedure and
memorize the new values. The display will go off for a moment,
and then it will come on again.
- If no key is pressed for 20 seconds, you will exit the proce-
dure and any changes made will not be saved.
NOTES
- When I2 is 16, electrical consumption of the spa is limited
to 16A. Under this condition you can simultaneously turn on
a hydromassage pump at low speed and the heater. When y-
ou turn on the pump at high speed, the heater is turned off.
- When I2 is 32, maximum electrical consumption is selected.
- It is not advisable to activate the consumption limiter if the s-
pa is installed where temperatures often drop below 0 °C because
this limits the anti-freeze protection (see related chapter).
I

CONTROL PANEL AND FUNCTIONS

Below you will find a description of the functions of your s-
i
pa and the methods for activating them via the keys of the
control panel (
7).
Andros - Oxia
A
Andros - Oxia
B
I
respective LED will flash. Press it again to go to high speed
(the LED will be on and steady). Press the button a third
time to shut down the pump (the LED turns off).
NOTES
- If the pump is activated via the button (at low and high
keys to change "x"
speeds), it will automatically shut off after 20 minutes un-
key. less turned off earlier by the user.
Note that when the pump starts automatically at low speed
(such as during a filtering cycle or when heating the wa-
ter), it can not be shut off from the display. It can however
be set to high speed by pressing the appropriate button.
In the instance where the energy limiter has been activat-
ed, by turning on the pump to full speed, the heater, if on,
switches off.
I
The jets integrated in the massage seats allow you to di-
rect the water at specific points of your back for in-depth
massage that relaxes the muscles and reduces stress.
According to your position, the whirlpool jets massage the
lumbar area, shoulders, arms, hips, thighs or calves.
The vertical jets are designed for relaxing foot and ankle
massage, improving the circulation. Since all of the jets
can be direction-adjusted, you can aim the jets at tense or
stiff muscles. The warmth and the stimulating flow of the wa-
ter will increase blood flow.
In some jets the water flow can be adjusted via the intake
outer ring nut.
27
Kios Friendly
Kios Friendly
"Pump" key
Press the button once to start the pump at low speed; the
Whirlpool nozzles and their layout