Clearray™ Maintenance - Jacuzzi andros Montageanweisung, Bedienung Und Wartung

To clean the filter, remove the cover from the skimmer
and follow the steps indicated in
i
9
1
2
i
9a
Separate the filter folds and clean with a jet of pressurised
water.
If the filter is clogged, it is advisable to use specific products for
the removal of encrustation and grease, available from author-
ized Jacuzzi ® dealers and service centres.
Refit, repeating the operations in reverse order.
CAUTION
After cleaning the filter, do not re-start the s-
pa until you have re-assembled all compo-
nents
i i
9 (Kios Friendly: 9a).
4
3
I
CAUTION
Make sure that all users know how to use the Maxi-
Jacuzzi safely.
Keep in mind that the more often you use the spa, the more
frequently you need to check the quality of the water.
Ensure that the chemicals used are suitable for use in spas.
Chemicals designed for swimming pools must not be used. Wa-
ter treatment of swimming pool water and spa water is very d-
ifferent.
CAUTION
READ AND FOLLOW ALL THE INSTRUCTIONS
RELATED TO THE USE AND STORAGE METH-
ODS FOR CHEMICAL PRODUCTS, KEEPING
STRICTLY TO THE MANUFACTURERS IN-
STRUCTIONS ON THE PACKETS.
After adding the chemicals, the filtering system should be run
for at least 30 minutes to ensure complete dilution in the water.
Never clean the filter(s) when the pump is running.
Turn the main switch off first.
Never start the pump and the heater if the water lev-
el is not above the hydromassage nozzles. Always fill
the Maxi Jacuzzi ® up to the mark on the skimmer.
Always turn the main switch off when the spa is empty.
I
CLEARRAY™ MAINTENANCE
The Clearray™ filtering system uses a UV lamp. The lamp
must be replaced after one year.
CAUTION
Do not carry out any UV lamp cleaning or re-
placement operations. Staring at the UV lamp
when on may cause serious harm to sight or
even blindness. Contact the dealer or an au-
thorised assistance centre.
36