Optional Accessories - Comet ETM series Bedienungs- Und Wartungseinleitung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

• external detergent suction hose kit

• instruction manual - safety precautions;

• instruction manual - operation and maintenance;

• warranty certificate;

• after-sales centre booklet;

• EC declaration of conformity;

• nozzle cleaning pin.

In case of problems, contact your dealer or an authorised after-sales centre.

The standard fittings of the high-pressure cleaner can be integrated with the following range of accessories:

•

type water mains disconnector: mandatory for connecting up to the drinking water mains.

• sandblasting lance: designed to clean surfaces, eliminating rust, paint, scale, etc.;

• drain cleaning kit: designed to unblock pipes and ducts;

• rotating-nozzle lance: designed to remove resistant dirt;

• foam lance: designed for more effective detergent distribution;

• lances and nozzles of various types.

• Connect the quick coupling (15) of the hose (14) to the water outlet connection (7), screw down and secure.

Operation E in fig. 6.

• Screw up the connection (13) of the high-pressure hose to the thread of the spray gun (9) and tighten well

using two 22 mm fixed wrenches (not supplied)

• Fit the filter (21) in the water inlet connection (20). Fit the seal (22) in the water inlet quick-fit connection (23)

and screw up to the connection (20). Operation A in fig. 2.

• Move the high-pressure cleaner to work position.

• Completely unwind the high-pressure hose (14).

• Attach a supply pipe to the water inlet's quick connection (23) using a normal garden connector. Operation F

in fig. 6.

• Open the water supply tap and make sure this is not dripping;

- if the connection is made to the drinking water mains, a

used, in conformity with EN 12729 standard, and available from your dealer (fig. 5). With regard to its use,

refer to the relative instruction manual;

- in case of supply from a water tank, introduce the suction hose inside the tank and make sure the vertical

distance between the water level and the pump is no more than 1.5 m (4.9 ft). Operation G in fig. 5.

• Make sure the master switch (1) is on "0" position and insert the plug. Operation C in fig. 6.

• Move the master switch (1) to position "1".

• Press the spray gun lever (19) and wait for a continuous jet of water to come out;

: in case of supply from a water tank, load the pump by pressing the "Priming" button (27) fig. 5;

ETM 130

release this when a continuous jet of water starts to come out of the spray gun.

• Move the master switch (1) to "0" position and connect the lance hose (10) to the spray gun (9), tightening

well. operation B in fig. 6.

• Make sure the nozzle holder head (11) is not in the detergent dispensing position

(refer to "

ETM 150]

• Start the high-pressure cleaner again moving the master switch (1) to position "1".

• Press the gun spray lever (19), making sure the spray of the nozzle is even and this is not dripping.

• If necessary, adjust the pressure by turning the knob (6). Turn clockwise to increase pressure, anticlockwise

to decrease it.

[ETM 100, ETM 130, ETM 150]