Overheating During Filtering Cycles; Clearray; Hydromassage Activation; Underwater Spotlight - Jacuzzi city spa Montageanweisung

Temperature adjustment LED
heater LED
filtering LED
Spotlight operation LED
Pump operation LED
pump
spotlight
viewing and adjusting temperature,
parameters, functions
u The filtering cycle may be suspended by the anti-freeze pro-
tection ("Smart Winter") or due to overheated water. Refer to the
respective chapters.
u When keeping the key
seconds: the term dx will appear on the display.When pressing
it briefly and repeatedly, the terms sy and Cr will appear ("Cr"
indicates that sanitation with ClearRay™ has been set, whilst "O3"
indicates that sanitation with Ozono has been set).
NOTE: the default value is "Cr".
u When pressing it again, the term LL1 appears on the display
("1" indicates the presence of the level sensor, whilst "0" indicates
the exclusion of the level sensor).
NOTA: the default value is "1".
ATTENTION: we recommend that you do not change the de-
fault configuration parameters "Cr" and "LL1".

Overheating during filtering cycles

During the filtering cycle, if the water temperature exceeds the
set point by more than 1 °C (see the chapter "Setting the water heating
temperature") and it does not decrease at least 1 °C in the following
3 hours, the cycle will be suspended until the temperature does not
decrease by at least 1 °C below the set point value.
Even if the water temperature is high (due to excessive sunlight,
for example), filtering is ensured for at least 3 hours.
ClearRay ™
The ClearRay™ system uses UV technology which relies on elec-
tromagnetic energy generated by the sun and, by means of a natu-
ral process, reliably and securely improves the disinfecting action,
reducing the need for chemical products to treat the water.
held down for approximately 5
u Operation of the ClearRay™ system is automatic and is de-
pendent upon activation of the circulation pump .

■ Hydromassage activation

u Press the key
once to activate the pump: the relative LED
will light up.
Press the key a second time, the pump will turn off (LED off ).
NOTES
If the pump is activated via the button, it will automatically shut
off after 20 minutes unless turned off earlier by the user.

■ Underwater spotlight

u Press the key
to activate the spotlight located on the wall
of the tub (the LED comes on).
u The spotlight will stay on for three hours, but it can be turned
off before that by pressing the key again. Refer to the user's man-
ual for the operation of the various sequences of colours.
27
(multicoloured light)
✐
5