Using The Device; Switching The Device On And Off; Setting The Welding Current; Setting The Wire Feed - Parkside PFDS 120 A2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Now the wire feed system pushes the
„
welding wire through the cable assembly
and the torch
12
As soon as 1 – 2 cm of the wire
„
protrudes from the torch neck
release the torch
(see Fig. P).
Switch off the welding device on the
„
main switch.
Screw the welding nozzle
„
Make sure that the welding nozzle
matches the diameter of the welding
wire used (see Fig. Q). When using the
delivered welding wire (Ø 0.9 mm),
the welding nozzle with the
0.9 mm must be used.
Push the torch nozzle
„
torch neck with a turn tot the right
(see Fig. R).
Always unplug the mains
plug from the socket prior to each mainten-
ance task or preparatory work in order to
prevent the risk of an electric shock, injury or
damage.
z Using the device
z Switching the device on
and off
Switch the welding device on and off
„
on the main 5 switch. If you do not
intend to use the welding device for an
extended period, remove the plug from
the power socket. This is the only way to
completely de-energise the device
z Setting the welding current
The switches on the front of the welding
7
device can be used to set the desired weld-
ing currents.
The rotaryswitch for welding current setting
.
10
,
33
button again
11
back on.
15
15
labelling
15
back on to the
9
33
Assembly / Using the device
on the front of the welding machine can
7
be used to set the desired welding currents.
The corresponding settings can be found in
the following table.
Voltage (V) Wire feed
A 2 – 4
B 3 – 5
C 3 – 6
D 4 – 8
E 5 – 9
F 5 – 10
G 5 – 10
The necessary welding current depends on
the welding wire diameter used, the material
thickness and the desired penetration depth.
z Setting the wire feed
In order to generate a constant arc, the
setting wheel for the wire feed
used to fine-tune the wire feed. You are
recommended to use a setting in the middle
range to start with, and then reduce or
increase the speed as required.
The necessary welding current depends on
the welding wire diameter used, the material
thickness and the desired penetration depth.
Similarly, the gaps to be bridged between
the workpieces to be welded must be ob-
served.

Overload protection

The welding device is protected against
overheating by means of an automatic
protection device (thermostat with automatic
restart). The protective device interrupts
the overload of the current circuit and the
Welding
current
25 – 75
55 – 85
60 – 100
65 – 105
75 – 110
80 – 115
85 – 120
8 can be
GB/MT 83