Mounting; Fit Welding Mask; Using The Device; Welding Preparation - Parkside PESG 120 B4 Originalbetriebsanleitung

z Mounting

Fit welding mask

z z
Fit the handle
8
„
mask , as shown in Fig. B.
7
Fit the protective glass
„
welding mask
7
The protective glass
„
pushed in at the top.
Note: If it is not possible to push the
protective glass
10
gently on the protective glass
the outside.
z Using the device

Welding preparation

z z
Note: If you adjust the current, check
whether the manual wheel
move and that the lead screw is not
jammed.
Note: If the clamping force of the
electrode holder
5
terminal decreases, replace these
4
immediately.
Connect the power cable.
„
Set the ON/OFF switch
„
"ON" position. The power indicator
lights up, the procedure can start.
To stop the procedure, set the ON/
„
OFF switch to the "OFF" position.
2
Note: If the yellow control lamp
lights up, then this indicates overheating.
The power circuit is shut off automati-
cally. The procedure is stopped.
Attach the earth terminal
onto the workpiece or to the base on
which the workpiece is positioned.
Note: Make sure that there is direct
contact with the workpiece. You should
onto the welding
onto the
10
, as shown in Fig. B.
must be
10
in fully, then press
from
10
can still
3
and the earth
to the
2
6
straight
4
Mounting / Using the device
therefore avoid lacquered surfaces and/
or insulating materials.
Note: The welding mask
always be used during welding
operations.
It protects the eyes from the light radia-
tion emitted by the arc and therefore
permits a clear view of the workpiece.
Note: The weldable material thickness
is 1.5 - 3.0 mm.

Welding

z z
Once you have connected all the elec-
trical connections for the power supply
as well as for the welding current circuit,
proceed as follows:
Insert the non-coated end of the
„
electrode into the electrode holder
and connect the earth terminal
with the workpiece. Please ensure
good electrical conductivity.
The device has a detent to set the
„
electrode thickness. Switch the
device on by setting the ON/OFF
switch to the "ON" position.
2
Then select the electrode thickness
using the manual wheel
or 2.0 mm electrodes, set the manual
wheel to the 1.6 / 2.0 position.
3
For 2.5 mm electrodes set the
manual wheel
Hold the welding mask
„
your face and guide the tip of the
electrode over the workpiece as if
you were going to strike a match.
This is the best way to ignite the arc.
Use a sample to test whether you
„
have the right electrode and current
strength on a sample.
ATTENTION!
Do not dab the workpiece with the
electrode. It could be damaged and
it could be more difficult to ignite the
must
7
4
: For 1.6
3
to the 2.5 position.
3
in front of
7
GB 17
5