Using The Device; Switching The Device On And Off; Setting The Welding Current; Setting The Wire Feed - Parkside PFDS 33 B4 Montage-, Bedienungs- Und Sicherheitshinweise

17
† Push the torch nozzle
torch neck with a turn tot the right
(see Fig. O).
Always unplug the mains
plug from the socket prior to each mainten-
ance task or preparatory work in order to
prevent the risk of an electric shock, injury or
damage.
z Using the device
z Switching the device on
and off
† Switch the welding device on and off
5
on the main switch. If you do not
intend to use the welding device for an
extended period, remove the plug from
the power socket. This is the only way to
completely de-energise the device
back on to the
7
32
Assembly / Using the device
z Setting the welding current
The switches on 8 ,
ing device can be used to set the desired
welding currents. For example, if the MIN
9
switch and the 1
position, the welding current is 40 A and the
duty cycle is at 60 %.
8
If the MAX switch and the 2
are set to down position, the welding current
is 90 A and the duty cycle is at 10 %.
The necessary welding current depends on
the welding wire diameter used, the material
thickness and the desired penetration depth.
z Setting the wire feed
In order to generate a constant arc, the
setting wheel for the wire feed
used to fine-tune the wire feed. You are
recommended to use a setting in the middle
range to start with, and then reduce or
increase the speed as required.
The necessary welding current depends on
the welding wire diameter used, the material
thickness and the desired penetration depth.
Similarly, the gaps to be bridged between
the workpieces to be welded must be ob-
served.
Overload protection
The welding device is protected against
overheating by means of an automatic
protection device (thermostat with automatic
restart). The protective device interrupts
the overload of the current circuit and the
yellow overload protection control lamp
illuminates.
† Allow the device to cool down (approx.
15 minutes) for the activation of the
protection device. As soon as the yellow
overload protection control lamp
out, the device is ready for operation
again.
9 the front of the weld-
switch are set to the up
9
switched
10
can be
goes
6
GB/NI/IE
8
6
19