Environmental Protection - GGP ITALY EL 340 Li Gebrauchsanweisung

When recharging is completed, the green LED LIGHT (5a) will
light up continuously.
NOTE - When the red LED light (5a)on the battery charger lights
up, it indicates several particular situations:
– a steady light, without battery, means the battery charger is
energised, but not operational as the battery is not inserted;
– a steady light, with the battery inserted, means that the battery
charger is operating outside of the foreseen temperature range,
between 0° and +45 °C. Recharging resumes automatically as
soon as the battery charger is placed in its allowed temperature
range.
– a flashing light means that recharging is not possible as the bat-
tery is already charged, or that it cannot be recharged because
the contacts are dirty or the battery is defective and must be
replaced.
NOTE - If the LED does not come on, it means that there is no
power to the socket or the battery charger is broken.
4.4c
Refitting the battery on the machine
When recharging is completed:
– r emove the battery (4) (do not keep recharging when recharging
is completed);
– d isconnect the battery charger (5) from the mains power supply:
– o pen the hatch (1) on the machine, insert the battery (4) in its
housing on the machine and turn the lever (3) to lock it into place
and ensure electrical contact.
– close the hatch (1) completely again.

5. ENVIRONMENTAL PROTECTION

Environmental protection should be a priority of considerable im-
WHAT TO DO WHEN ...
• The motor does not start when you switch it on
• The motor stops while mowing
• The motor is on but the blade does not turn
• Excessive noise and/or vibrations while mowing
• Reduced battery power reserve
• T he battery charger does not charge the battery
(red led on or flashing)
• T he battery charger does not charge the battery
(no red led on)
Source of problem
No safety key or not inserted correctly
No battery or not inserted correctly
Battery exhausted
The heat protection comes on
The motor does not start immediately
Battery not inserted correctly
Battery exhausted
The protection comes on
Obstructions blocking blade rotation
Blade has loosened
Blade has loosened or is damaged
Difficult mowing conditions absorbing more current
Insufficient battery for mowing needs
Battery not inserted in charger correctly
Environmental conditions are not suitable
Dirty contacts
No power supply to battery charger
Defective battery charger
In any other situation, not listed, please consult your Dealer or a Service Centre.
portance when using the machine, for the benefit of both social
coexistence and the environment in which we live.
– Try not to cause any disturbance to the surrounding area.
– Scrupulously comply with local regulations for the disposal of
waste materials after mowing.
– Scrupulously comply with local regulations for the disposal of
packaging, deteriorated parts or any elements with a strong
environmental impact; this waste must not be disposed of as
normal waste, it must be separated and taken to specified waste
disposal centres where the material will be recycled.
– When decommissioning, do not pollute the environment with the
machine, hand it over to a disposal centre, in accordance with
the local regulations in force.
6. ACCESSORIES
WARNING: For your safety, it is strictly prohibited to fit any other
accessory other than those included in the following list, as they
have been exclusively designed for the model and type of machine
you are using.
6.1
Quick battery charging
It reduces the time necessary for recharging a standard battery by
approximately an hour.
6.2
Extended battery
It increases machine power reserve considerably and reduces the
number of recharging cycles.
For any doubts or problems, please do not hesitate to contact your
nearest Customer Service Centre or Your Dealer.
Corrective action
Insert the key till it "clicks" (
Open the hatch and make sure the battery is fitted
properly (
Check charge status and recharge the battery
( 4.3)
Allow the machine to cool
Hold the button pressed for 1-3 seconds (
Open the hatch and make sure the battery is fitted
properly (
Check charge status and recharge the battery
( 4.3)
Wait at least 5 minutes and then restart the machine
Remove the safety key; wear work gloves and
remove grass or residue present in the lower part of
the machine and/or discharge channel
Stop the motor immediately and contact a Service
Centre (
Stop the motor immediately and contact a Service
Centre (
Optimise use (
Use a second battery or an extended one (
Check it is inserted correctly (
Charge the battery in an environment with a suitable
temperature (
Clean contacts
Check the plug is inserted and that the socket
receives power
Replace with original spare part
3.2)
4.3c)
4.3c)
4.1)
4.1)
3)
4.3b)
4.3)
2.2)
6.2)
39