Environmental Protection - GGP ITALY PAN 504 series Gebrauchsanweisung

next start-up difficult.
3) Should it be necessary to access the lower part, only tilt
the machine from the side shown in the engine hand-
book; following the relative instructions.
4) Do not drip petrol onto the plastic parts of the motor or
the machine to prevent damaging them and remove all
traces of spilt petrol immediately. The warranty does not
cover damage to plastic parts caused by petrol.
5) In AVS models: in the event of abnormal handle vibra-
tions, check the vibration-proof sleeves and contact
your Dealer to replace them if damaged or worn.
4.1
Each intervention on the blade is best if conducted
at a specialised Centre that has the most appropriate tools.
Only blades with the following codes must be used on this
machine:
81004366/2 (for model 504)
81004381/1 (for model 534)
81004383/0 (for model 534+AVS)
Blades must always be marked
lution, the above mentioned blade may be replaced in time
by others, with similar interchangeable and operating safe-
ty characteristics.
Reassemble the blade (2) with the code and markings fac-
ing the ground, following the order indicated in the illustra-
tion.
Tighten the central screw (1) using a torque wrench set to
35-40 Nm.
4.2
On models with drive units, adjust the tension of the
belt with the nut (1) to get the right measurement (6 mm).
4.3
To recharge a flat battery, connect to the battery
charger (1) following the instructions in the battery mainte-
nance handbook.
Do not connect the battery charger directly to the engine
terminal. It is not possible to start the engine using the bat-
tery charger as a power source, as it may get damaged.
If the machine is to remain inactive for a long period, dis-
connect the battery leads after making sure that the battery
is fully charged.
4.4
To clean inside the machine, use the hosepipe con-
nector (1) provided.
Always stand behind the machine's handle when cleaning.

5. ENVIRONMENTAL PROTECTION

Environmental protection should be a priority of consider-
able importance when using the machine, for the benefit of
both social coexistence and the environment in which we
live.
– Try not to cause any disturbance to the surrounding area.
– Scrupulously comply with local regulations and provi-
sions for the disposal of waste materials after cutting.
– Scrupulously comply with local regulations and provi-
sions for the disposal of pakagings, oils, petrol, batteries,
filters, damaged parts or any elements which have a
strong impact on the environment; this waste must not
be disposed of as normal waste, it must be separated
and taken to specified waste disposal centres where the
material will be recycled.
– At the time of decommissioning, do not pollute the envi-
ronment with the machine, hand it over to a disposal
centre, in accordance with the local laws in force.
6. ACCESSORIES
WARNING: For your safety it is strictly prohibited to fit any
other accessory other than those included in the following
26
. Given the product evo-
list, they have been exclusively designed for the model and
type of machine you are using.
6.1
Kit "Mulching" (if not supplied)
It finely chops the grass cuttings and leaves them on the
lawn, instead of collecting them in the grass-catcher.
Should you have any doubts or problems, do not hesitate
to contact the nearest Service Centre or your Sales outlet.