Configuration - Mettler Toledo xpress XTC Bedienungsanleitung

STANDARD COUNTING SCALE
The following diagram gives an overview of the program blocks and sub-blocks.
Service Mode
Test Block
Expended Weight
Once the Service Mode is accessed, the scale directly prompts to the first block. Press the key
toggle among blocks [tESt], [CALIbr], [COntrL] and [End].Service Mode sample display - Test block
Weight Data
S 1 t E S t
>0< lb kg g Net ID APW B/G T
When a block is displayed, press the key
Weight Data
S 1 1 o F F
>0< lb kg g Net ID APW B/G T

CONFIGURATION

Blocks
S1 Test Block
S2 Calibration
Block
Calibration Block
CAL Units
GEO Code
Capacity
Increment
Linearity
Calibration
Count
PT %Accy M < > PCS
Count
M < > PCS
PT %Accy
S1.1 Expanded Mode
Off = Normal weight mode
On = Expanded mode, the display division is 100000
In this block you can configure the parameters related to calibration and calibrate
the TC.
S2.1 Calibration Unit
1 = kg
2 = lb
The weight unit cursor under the weight display window will indicate the unit being
selected.
Control Block
Operator Access
Country
key to access the first sub- block.
Sub Blocks / Parameters
25
End Block
Save/Abort
to