Operating The Weighing Platform; Installation, Configuration, Service And Repair - Mettler Toledo PBD7 Serie Bedienungsanleitung

0.000 kg
10.520 kg
0.000 kg
8
Operation
Function check
Before starting a weighing series, perform a function check of the weighing platform and
the connected weighing terminal.
1. Make sure that the weighing platform is connected to a weighing terminal and that the
weighing terminal is switched on.
2. Make sure that the weighing platform is unloaded and the display of the weighing
terminal shows 0.
3. Load the weighing platform.
The indicator must show a value different from 0.
4. Unload the weighing platform.
The indicator must return to 0.
Verification test
For a verification test refer to the User manual of the connected weighing terminal.
If the verification seal is broken, verification is no longer valid.

3.3 Operating the weighing platform

For best weighing results observe the following:
▲ To achieve best weighing results place the weighing sample always on the same
position on the weighing platform.
▲ Avoid abrasive and wear processes.
▲ Avoid falling loads, shocks and lateral impacts.

3.4 Installation, configuration, service and repair

➜ For installation, configuration, service and repair of the weighing platforms call the
METTLER TOLEDO Service.
PBD7- / PBA7-series 30403592A