Mettler Toledo xpress XTC Bedienungsanleitung Seite 53

3) Paper cut error
Error Description POWER lamp
Paper cut error Off
Note
1) If the cutter doesn't return to the home position, or doesn't perform the
initial movement, it cannot be recovered.
2) If the paper is jammed, turn the power off, clear the jammed paper, then
turn the power ON.
3) Handling paper cut errors that occur in the printer status.
STAR Mode: Non recoverable error
ESC/POS MOde: Recoverable error
4) Paper detection error
Error Description POWER lamp
Paper out error On
Paper near end On
ERROR lamp
Recovery Conditions
Flashes at 0.125
Recovered If the cutter returns to the
second intervals home position after turning the power
OFF and ON.
Restoration is also possible with the
<DLE><ENQ>n command when in
the ESC/POS mode.
ERROR lamp
Recovery Conditions
Flashes at 0.5
Automatically recovered by loading
second intervals
a new paper roll, then closing the
printer cover.
Flashes at 2
An error is displayed in the STAR
second intervals
mode, but printing continues without
stopping.
Operations in the ESC/POS mode are
determined by the <ESC> "c4" n com-
mand.
In other words, recovery will be at-
tained automatically when paper is
set in the printer and the cover closed
after printing has stopped if the pa-
rameter has been set to cease printing.
If the parameter has not been set to
cease printing, the error will be dis-
played but printing will continue.
– 12 –