Removing The Storage Battery (Figure E); Charging The Storage Battery (Figure F); Inserting The Storage Battery; Low Voltage Warning - lidl 284749 Gebrauchsanweisung

Removing the storage battery
(figure E)
Open the cover on the storage battery compart-
ment (1j) and remove the storage battery (9).
PLEASE NOTE: If the storage battery
connector plug (9a) (9b) is connected to the
quadrocopter (1), then you must release this from
the quadrocopter (1) before removing the storage
battery (9) .
Charging the storage battery
(figure F)
1. Remove the storage battery (9) from the
storage battery compartment (1g) on the qua-
drocopter (1).
WARNING: Never charge the storage
battery (9) while it is still mounted on the
quadrocopter (1), it could catch fire and destroy it.
Do not remove the outer case from the storage
battery (9). This serves to protect the storage
battery (9).
2. Connect the end of the cable (6a) on the USB
charger cable (6) to the storage battery plug
connector (9a) on the storage battery (9).
3. The charge control lamp on the USB charger
cable (6) switches on.
4. Insert the other end of the cable (6b) on the
USB charging cable (6) into a USB port on an
active computer or a charging station with USB
port.
5. The charge control lamp on the end of the
cable (6b) switches off.
PLEASE NOTE: The charging time is
approx. 90 - 100minutes.
6. The charge control lamp switches on as soon
as the storage battery (9) is charged.
7. After charging disconnect the storage battery
plug connection (9a) from the end of the cable
(6a) on the USB charger cable (6) and pull
the end of the cable (6b) of the USB charging
cable (6) from the USB port.
8. Insert the storage battery (9) correctly into the
storage battery compartment (1g) (see 'starting
to fly').
30 GB/IE

Inserting the storage battery

1. Open the cover (1i) on the storage battery com-
partment (1g) and insert the storage battery (9).
2. Connect the storage battery plug connections
(9a) (9b) to the quadrocopter (1).
3. Close the storage battery compartment (1i)
completely.

Low voltage warning

The lights (1h) begin to flash when the storage
battery (9) is almost empty. Land the quadro-
copter (1) as soon as you notice this.

Setting the camera (figure G)

The camera (1e) is secured under the quadrocopter
(1). Turn the wheel on the camera up or down in
order to move the position of the camera lens.
PLEASE NOTE: The camera (1e) features
a small status LED. In order to provide gre-
ater visibility, camera functions are also displayed
via the LED's on the Quadrocopter (1).

Transferring data (figure H)

The recorded photos and films are saved on the
micro-SD card (10). Proceed as follows in order to
transfer the data on a computer to a device with
an USB port (for example a television):
1. The micro-SD card (10) is in the camera (1e).
Press on the micro-SD card (10) and remove it
from the camera (1e).
2. Push the micro-SD card (10) all the way into the
micro-SD card USB stick (7) as shown in figure H.
PLEASE NOTE: Make sure that the
micro-SD card (10) is inserted correctly. It
must disappear completely into the micro-SD card
USB stick (7).
3. Insert the micro-SD card USB stick (7) into the
USB port of a computer.
4. The computer recognises the micro-SD card
USB stick (7) and you can copy the data onto
the computer.