Cleaning/Maintenance; Cleaning & Maintenance; Storage - Parkside PNTS 1400 G3 Originalbetriebsanleitung

GB IE NI

Cleaning/Maintenance

Pull out the mains plug.
Danger of electric shock.
Always check the appliance before
use for any obvious faults such as
a defective mains cable, and have
these repaired or replaced.
Cleaning the device (Fig. A, L) :
Never hose the device down with
water. Never use aggressive
cleaning agents or solvents. This
could damage the appliance.
• After use, empty the stainless steel
container (13):
- For liquid dirt, open the drain screw
(14) to allow the vacuumed liquid
to drain out. Use machine handle to
pour out the liquid residue inside the
container (13).
- remove the motor head (5)(see"Motor
head removing / assembling ")
- hold the upper machine handle (2)
with one hand and the other hand on
the bottom of stainless steel container
(13)
- pour out the liquid residue
- For dry dust, use machine handle
to pour out the dry dust inside the
container, same as above.
• Clean the waste tank with a damp cloth.
• Wash the foam filter (35) with lukewarm
water and soap, and allow to dry.
• Beat the dust out of the cartridge filter (36)
and clean it with a paint brush or hand
brush.
16
CY
• Replace the dry dust bag (33) when full
(see" Cartridge filter / foam filter / dry
dust bag disassembling / assembling ")
Storage (Fig. A, M)
1. Unplug the power cord (8) and wind it
around the motor head handle (6).
2. Plug the telescopic tube (29) into the
telescopic tube holder (9) on the motor
head (5).
3. Wind the suction hose (23) around the
motor head handle (6).
4. Store the rest accessories on the
accessory mount (16) of the steering
castor kit (15).
5. Store the machine in a dry place and out
of reach of children.