Operating Instructions; Cleaning/Maintenance; Cleaning & Maintenance; General Cleaning Work - Parkside PAS 1200 D3 Gebrauchsanweisung, Originalbetriebsanleitung

GB IE NI

Operating Instructions

The vacuuming of glowing
embers and of materials that
are combustible, explosive or
harmful to health is prohib-
ited. There is a risk of injury!
• Place the equipment on a level surface
that is not heat sensitive.
• Always use the suction tube (
vacuuming. In case of minor contami-
nation, hold the suction tube (
approx. 1 cm above the ash. Remove
large ash volumes by directly immersing
the suction pipe.
• Vacuum only cooled ash at less than
40°C.
• When vacuuming, keep checking the
metal container (
hose ( 15) for rises in temperature.
• In the event of a rise in temperature,
switch off the equipment and discon-
nect at the plug. Place the equipment
outside and monitor it as it cools.
• During breaks, you can insert the
suction pipe (
( 2) on the container cover (
or into an attachment port on one of
the rollers (
• Always use the carry handle (
transporting the equipment.
• The metal container (
filled to no more than half, so the pleat-
ed filter (
18) always remains clear.
• Empty the container outside in order to
avoid mess (see "cleaning/maintenance").
• Clean the pleated filter (

"Cleaning/Maintenance"):

- if suction power declines
- if the inspection window on the con-
tainer lid of the blockage indication
system ( 7) turns red.
10
CY
16) for
16)
13) and suction
16) into the holder
14).
13) may be
18) (see
Filter cleaning switch
Insert the mains plug of the device
and turn the device on.
If the suction power decreases, you can
improve it by pressing the filter cleaning
switch (
1. Turn the machine on.
2. Close the suction opening of the suction
pipe/suction hose (
hand.
3. Press the switch (
downwards to unlock.
Keep the switch pressed and
turn it 70° clockwise until you
hear a clicking sound.
4. Now release the switch.
Repeat the procedure three times.
Cleaning/Maintenance
Pull out the mains plug.
Danger of electric shock.
Never hose the appliance down
10) with water. Never use aggressive
cleaning agents or solvents. This
could damage the appliance.
5) for

General Cleaning Work

Clean the equipment after each use:
• Carry out cleaning outside in order to
avoid mess.
• Remove the container lid (
empty the metal container (
Clean the metal container (
water and allow it to dry.
• After removing the suction
hose (
particles from the connections. This en-
3)
16/
3)
15), clean the dust and soot
15) by
10) and
13).
13) with