Ultradent VALO GRAND Bedienungsanleitung Seite 5

Quick Warning Guide
CURING MODE: Standard Power mode
USES: Curing of restorative materials with photo initiators.
TIMING INTERVALS: 5, 10, 15, 20 seconds.
• VALO GRAND Corded curing light defaults to this mode when it is INITIALLY powered on. The Status Light is green and the green Timing Lights
are solidly illuminated.
• To change timing intervals, quickly press the Time/Mode Button.
• Press the Power Button to cure. To stop curing prior to completion of a timing interval, press the Power Button again.
CURING MODE: High Power Plus mode
USES: Curing of restorative materials with photo initiators.
TIMING INTERVALS: 1, 2, 3, 4 seconds.
• From Standard Power mode, press and hold the Time/Mode Change Button for 2 seconds. The green Timing Lights will illuminate and flash. The
Status Light will illuminate as a solid orange light, indicating High Power Plus mode. A two-second power tack is the most commonly used timing
interval in this mode.
• To change timing intervals, quickly press the Time/Mode Button.
• Press the Power Button to cure. To stop curing prior to the completion of a timing interval, press the Power Button again.
• To return to Standard Power mode, press and hold the Time/Mode Change Button for 2 seconds, this will cycle to Xtra Power Mode, then release,
hold for 2 seconds, and release. The green light will be solid with solid green timing lights, indicating Standard mode.
CURING MODE: Xtra Power mode
USES: Curing of restorative materials with photo initiators.
TIMING INTERVAL: 3 seconds only (Note: there is a 2 second safety delay at the end of each curing cycle).
• From the Standard Power mode, press the Time/Mode Change Button for 2 seconds, release, press again for 2 seconds, and release. Three of
the green Timing Lights and the orange Status Light will illuminate and flash, indicating Xtra Power mode.
• Press the Power Button to cure. To stop curing prior to completion of a timing interval, press the Power Button again.
• To return to the Standard Power mode, press and hold the Time Button for 2 seconds.
WARNING: In Xtra Power mode, DO NOT expose soft tissue for more than 10 seconds. The Xtra Power mode has a 2-second safety delay to limit
heating during consecutive curing. At the end of the delay, beeping indicates unit is ready for continued used. If a longer cure is needed, allow 10
seconds between consecutive cures or consider a dual-cure product (composite or adhesive).
Note: If it is necessary to cure near soft tissue, cooling with an air stream is an option for keeping the area cooler.
Warnings
Call Customer Service Call Customer Service
for Repair for Repair
No sound.
Continuous 3 beeps
Flashing, 2 seconds
Prohibits operations
Allows operation
3