Ultradent VALO GRAND Bedienungsanleitung Seite 4

Instructions for Use:
1 - Connect the 9-volt power cord to the handpiece cord.
2 - Plug the power cord into any electrical outlet (100 -240 VAC). The timing lights will illuminate indicating the light is ready for use. The VALO
GRAND Corded curing light handpiece beeps twice when powering on.
3 - Place the VALO GRAND Corded curing light handpiece into a standard dental unit mounting bracket or accessory mounting bracket until ready to use.
4 - Prior to use, place barrier sleeve over VALO GRAND Corded curing light wand.
5 - Select the desired mode: VALO GRAND Corded curing light has 3 modes: Standard Power, High Power Plus, and Xtra Power. Each mode is
identified by the Mode/Status Light (green = Standard Power, orange = High Power Plus, flashing orange = Xtra Power). To change modes, hold
the Time/Mode Change button for 2 seconds and release. The Mode/Status light will change to the next mode.
NOTE: VALO GRAND Corded curing light is programmed to cycle from the Standard Power to the High Power Plus to the Xtra Power mode in
sequence. For example, to change from the Standard Power mode to the Xtra Power mode, it is necessary to cycle into the High Power Plus mode
and then to the Xtra Power mode.
VALO GRAND Corded curing light always stores its last used timing interval in each mode and will default back to that timing interval whenever the
modes are changed, or if the unit is unplugged and loses power.
SLEEP MODE: VALO GRAND Corded curing light will go into SLEEP mode after 1 hour of inactivity, as indicated by the green mode light blinking
slowly. Press any button to wake VALO GRAND Corded curing light and begin curing. VALO GRAND Corded curing light will automatically return to the
last setting used.
Precaution: Always wear amber colored safety glasses while the curing light is illuminated.
Quick Mode Guide
Mode
Power Button
Mode/Timing LEDs
Time Button
Time Options
To Change Time
To Change Modes
Legend
Quick Curing Guide: Recommended Curing Times for Optimal Results with VALO GRAND Corded curing light
Exposure times may need to be adjusted due to composite reactivity, shade, distance from the light lens to the composite, and depth of composite
layer if it is over 2mm.
Mode
Per Layer
Final Cure
2
Standard Power
5s 10s 15s 20s
Press and release Time Button quickly to cycle through time options.
Press and hold the Time Button for 2 seconds and release. VALO GRAND Corded curing light will cycle to next Mode.
Blinking LEDs
Solid LEDs
Standard Mode High Power Plus Mode
One 10 second cure
Two 10 second cures Three 4 second cures
High Power Plus
1s 2s 3s 4s
Xtra Power Mode
Two 4 second cures One 3 second cure
Two 3 second cures
Xtra Power
3s only