Troubleshooting; Fault Causes And Remedies - Silvercrest SMS 300 A1 Bedienungsanleitung Und Sicherheitshinweise

Troubleshooting

This section contains important information on fault identification and
rectification . Follow the instructions to avoid hazards and damage .

Fault causes and remedies

The following table will help you to identify and rectify minor malfunctions . If the
solutions presented below do not resolve the problem, please contact Customer
Service (see section Service) .
Fault
The appliance
does not suck .
The suction power
is too weak .
The UV-C lamp
does not light up .
The vibration
head 7
vibrate .
An unpleasant
odour escapes
from the appliance
during suction .
■ 14 │ GB │ IE │ NI │ CY
Cause
The appliance is not
switched on .
The plug is not plugged
in .
The mains socket is not
supplying power .
The dust container
full .
The dust filter
The suction opening
is blocked .
The automatic switch-off
device of the UV-C lamp
8 has been activated .
8
The UV-C lamp
appliance is defective .
The vibration function is
does not
not switched on .
Odours often develop
when new appliances
are used for the first time .
The appliance is
defective .
Remedy
Make sure that the appliance
is properly connected to the
power supply and press the
On/Off switch
Insert the power plug into the
socket .
Check the house fuses
3 is
Empty the dust container
4 is dirty . Clean the dust filter
Turn off the appliance, pull out
9
the plug from the wall socket
and remove the blockage .
Check the safety switches
left and right (see section
Safety switches) .
Contact Customer Service (see
8
or
section Service) .
Press the vibration button
The smell should disappear
after the appliance has been
used a few times .
Switch off the appliance, pull
out the power plug
socket and contact Customer
Service (see section Service) .
2 .
3 .
4 .
0
w .
from the
SMS 300 A1