Troubleshooting - Silvercrest SST 40 A1 Bedienungsanleitung

Troubleshooting

The following table will help you to identify and rectify minor malfunctions:
Fault
The appliance is
not working.
The appliance is
sucking up hardly
any dirt.
The appliance will
not charge.
The appliance will
not charge and all
indicator lamps 7
are flashing green.
NOTE
► If you cannot solve the problem with the above-mentioned steps, please contact
the Service Hotline (see section Service).
■ 14 │ GB │ IE │ NI │ CY
Possible cause
The battery is not charged.
The appliance is defective.
The battery is not sufficiently
charged.
The dirt container 0 is full.
The HEPA filter p is clogged. Clean the HEPA filter p.
The mains adapter l is not
inserted correctly into the
connecting socket
the mains socket.
The mains adapter l is
defective.
The appliance has been
charged too many times
in quick succession. The
overheat protection has
been triggered.
Remedy
Connect the appliance to
the mains adapter l.
Contact the Customer Service
department.
Connect the appliance to
the mains adapter l.
Empty the dirt container 0.
Check the connections of
the mains adapter l.
4/
Contact the Customer Service
department.
Disconnect the mains adapter
l from the mains socket. Pull
the barrel plug k out of the
connecting socket
the appliance. Wait a short
while and try again.
4 of
SST 40 A1