De Dietrich DOP1180X Betriebsanleitung Seite 57

2 / USING YOUR APPLIANCE
• 2 - Cleaning
R R e e m m o o v v e e t t h h e e g g r r i i d d s s a a n n d d t t r r a a y y s s f f r r o o m m t t h h e e o o v v e e n n
a a n n d d c c l l e e a a n n a a n n y y m m a a j j o o r r s s p p i i l l l l r r e e s s i i d d u u e e . .
Select "Cleaning" from the "Information" menu
(fig.1). Your oven indicates the dirtiness of the
cavity (grey zone in "DIRT") and suggests two
cleaning modes:
Choose the appropriate setting:
- - P P y y r r o o l l y y s s i i s s 2 2 h h 0 0 0 0
Pyrolysis system where the duration is
preselected: it takes 2h30 (2 hours of pyro +
30 minutes cooling) and cleans the inside of the
oven intensely and perfectly.
To delay the start time, select the end time and
change it by entering the desired end time for
the pyrolysis cycle by using the touch control +
(fig.2).
Note: If you have entered details of peak and off-
peak times, (see "Consumption" function) your
oven recommends cleaning the oven at off-peak
times to save money. However, you can change
this recommendation by changing the end of
pyrolysis time and starting the cleaning cycle
immediately if you choose. Enter by pressing
"OK".
The cleaning cycle begins. Your screen
indicates: the time, the pyrolysis end time as well
as the locking of the door symbolised by
- - P P y y r r o o c c o o n n t t r r o o l l b b e e t t w w e e e e n n 1 1 h h 3 3 0 0 a a n n d d 2 2 h h 1 1 5 5
Pyrocontrol is a pyrolysis system with a pre-
set duration: it takes at least 2 hours (1h30 of
pyro + 30 minutes of cooling) allowing you to
save energy.
If you wish to delay the start time, select the
end time and change it by entering the
desired end time for the pyrolysis cycle using
the touch control + (fig.3). Confirm by
pressing "OK".
- - E E n n d d o o f f p p y y r r o o l l y y s s i i s s
Your oven tells you when the pyrolysis
cleaning cycle is finished (fig.4).
When the unlocking takes effect, you can
open the door.
Simply remove the ash residue in the cavity
with a damp sponge.
Warning
Before starting a pyrolysis cleaning cycle, make sure that any accessories that are not
pyrolysis safe have been removed from the oven (sliding rails, baking trays, chrome-plated
grills, and so on) as well as any cookware. The side grills are pyrolysis safe and may be left
inside the oven during pyrolysis.
Fig.2
.
Fig.3
27
EN
Fig.1
Fig.4