Troubleshooting; Replacement Parts /Accessories; Error Correction - Parkside PWSA 12 B1 Originalbetriebsanleitung

GB MT

Troubleshooting

Switch off the tool and remove the battery before you service the
tool. Risk of electric shock!
Problems
Device doesn't start
Grinding tool does
not move although
the engine is run-
ning
Engine is slower
and stops
Grinding disc does
not rotate smoothly,
abnormal noises
can be heard
Replacement parts / Accessories
Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre via telephone
(see "Service-Center" page 79). Please have the order number mentioned below ready.
Item. Description .............................................................Order-No.
2 Cutting disc ....................................................................... 30211074
Clamping flange with clamping screw
14+3
80
Possible Cause
On/off switch (
defective
Engine faulty
Clamping screw is loose
Workpiece, remaining work-
pieces or remaining grinding
tools block drive
Device is overloaded through
workpiece
Clamping screw is loose
Cutting/grinding disc
defective
www.grizzly-service.eu

Error correction

5) may be
Repair by Customer Care
Tighten
„Changing disc")
Remove blockages
Reduce pressure on grinding tool
Workpiece unsuitable
Tighten
„Changing disc")
is
Change grinding disc
.................................. 91100646
clamping screw (see
clamping screw (see