Other Special Safety Instructions For Cutting Grinding - Parkside PWSA 12 B1 Originalbetriebsanleitung

GB MT
not intended for the electric
tool may not be sufficiently
shielded and are unsafe.
b) Depressed Center grinding
wheels must be pre-assembled
so that their surface not above
the level of the edge of the
guard stands out. An improp-
erly mounted grinding wheel,
which extends beyond the
level of the edge of the guard,
not sufficiently shielded.
c) The protective hood must
be securely attached to the
electric tool and adjusted
so that the greatest level of
safety is reached, i.e., the
smallest possible amount of
the grinder is exposed to the
operator. The protective hood
should protect the operator
from broken bits and acciden-
tal contact with the grinder.
d) Grinders may only be used
for the recommended attach-
ment options. For example:
Never grind with the side sur-
face of a cutting disc. Cutting
discs are for cutting material
using the edge of the disc.
Pushing sideways on these
grinders can break them.
e) Always use undamaged
clamping flanges of the cor-
rect size and shape for the
grinding disc you selected.
Suitable flanges support the
grinding disc and thus reduce
the danger of the grinding
disc breaking. Flanges for
cutting discs can be distin-
guished from flanges for other
grinding discs.
72
f) Do not use worn grinding
discs for larger electric tools.
Grinding discs for larger elec-
tric tools are not set up for
the higher rotation speeds of
smaller electric tools and can
break.
Other special safety instruc-
tions for cutting grinding
a) Avoid blocking the cutting
disc or pressing down too
hard. Do not make any exces-
sively deep cuts. Overloading
the cutting disc increases wear
and its tendency to tilt or block
and, with that, to kickback or
break the grinder.
b) Avoid the area in front of and
behind the rotating cutting
disc. When you move the cut-
ting disc by itself in the work-
piece, in the event that the
electric tool kicks back with
the rotating disc, it can spin
directly towards you.
c) If the cutting disc jams, or you
interrupt your work, switch
the device off and hold it until
the disc has come to a full
stop. Never try to pull the cut-
ting disc out of the cut while
it is still running, because it
can kick back. Identify and
correct the cause of the jam-
ming.
d) Do not switch the electric tool
on again as long as it is in
the workpiece. Allow the cut-
ting disc to first reach its full
rotational speed before you
carefully resume with the cut-