Troubleshooting; Error Correction - Parkside PWSA 12 B1 Originalbetriebsanleitung

GB CY

Troubleshooting

Switch off the tool and remove the battery before you service the tool.
Risk of electric shock!
Problems
Device doesn't start
Grinding tool does
not move although
the engine is run-
ning
Engine is slower
and stops
Grinding disc does
not rotate smoothly,
abnormal noises
can be heard
20
Possible Cause
Discharge the battery (
Battery ( 9) not inserted
On/off switch (
defective
Engine faulty
Clamping screw is loose
Workpiece, remaining work-
pieces or remaining grinding
tools block drive
Device is overloaded through
workpiece
Clamping screw is loose
Cutting/grinding disc
defective

Error correction

Charge the battery (
(observe the separate operating
9)
instructions for the battery and
charger)
Insert the battery (
(see "Operation")
5) may be
Repair by Customer Care
Tighten
„Changing disc")
Remove blockages
Reduce pressure on grinding tool
Workpiece unsuitable
Tighten
„Changing disc")
is
Change grinding disc
9)
9)
clamping screw (see
clamping screw (see