Control Panel; Adjusting The Temperature - Jacuzzi MOOD-Serie Bedienung Und Wartung

Turning on
the system
It is recommended to keep the
switch in position "II" and, if nec-
essary, disconnect the power
using the isolating switch located
upstream of the equipment.
(position "I" only permits the
light to be turned on)

Control panel

Basic operations
If the knob is not used for
a few seconds, the display
returns to stand-by mode
To return to the previous menu,
press the knob in correspondence
of the arrow (at the end of
each menu); to turn to the stand-
by mode, press the key
Selecting the type of sauna
Some models do not have a
steamer (bio sauna) and therefore
only the symbol is displayed

Adjusting the temperature

You can adjust the temperature
also while the sauna is operating
ATTENTION:
it is not recommended to set
temperatures above 100 °C
If you have not already done so, turn on the isolating switch located upstream of the
equipment and then turn the switch in the box to position "II" .
I
0
II
After switching on, the Jacuzzi® logo is displayed and then the display enters stand-by
mode (the symbols shown depend on sauna configuration).
Turn the knob to scroll the function and/or menu symbols (their meaning is displayed
at the top of the display).
Press the knob in correspondence of a symbol to select the relative function and/or
menu, then turn it again to adjust the value and press it to store the value.
26
20:51
Proceed as described to select the type of sauna desired.
20:51
You can adjust the value shown on the display from a minimum of 30 °C to a maximum
of 115 °C (Finnish sauna) or 70 °C (bio sauna).
20:51
37
26
20:51
26
20:51 20:51
---------------
-----------
26
55°
20:51 20:51
20:51 20:51
26
20:51
26
20:51