Jacuzzi MOOD-Serie Bedienung Und Wartung Seite 47

Alarm
button
The displayed message depends on
the selected language; the telephone
contacts and e-mail addresses to use
in the case of a fault and/or request
for information are also displayed
Sound system
(optional)
Troubleshooting...
The display
does not turn on
The button is used to turn off the heater and simultaneously activate the alarm circuit
(if connected).
1
2
ATTENTION!
The heater will remain hot for some time, even after switching the system off.
The equipment can be fit with speakers (located below the bench) that must be con-
nected during the installation phase to a cable radio system (refer to the preinstallation
instructions and the installation manual).
ATTENTION! During the normal cleaning phases, do not press down on the speaker
domes and/or membranes.
W
e always recommend carefully reading the manual before using Mood; in the instance
that there is an issue, refer to the following guide.
Some faults are shown on the display with a message, followed by the telephone
contacts and e-mail addresses to use if needed
If an error message appears that is not listed below, contact an authorized Jacuzzi® Service Centre.
lack of electric energy
switch on the electrical box
off
defective connection between the
control panel and the electrical box
energy savings mode activated
47
+
+
- check to see if the main switch is off and/or if
a fuse is burnt (contact your trusted electrician)
- turn on the switch located to the side of the
electrical box
- the cable connection could be faulty and/or
the connection could be incorrect (contact an
authorized Jacuzzi® Service Centre)
- turn the control panel knob to reactivate the
display
messaggio d'errore
fusibile termico
scattato
info@jacuzzi.eu
IT 848 840 840
DE 0711 933 247 20
ES 932 385 031
FR 0470 309050
UK 011 32727430
20:51
20:51