Jacuzzi MOOD-Serie Bedienung Und Wartung Seite 39

Turning on
the sauna
When the set temperature is
reached, the red colour stops
flashing and stays on fixed
If instead of the symbol the
symbol is displayed, this could
indicate that the humidity sensor is
disconnected or connected incorrect-
ly, or is malfunctioning. Contact an
authorized Jacuzzi® service centre
Turning on
the light
Hold down the key
in the sauna will turn on; the display will have the following configuration:
Finnish sauna
5:59:14
20:51
The countdown of the set time will appear at the top of the display, whereas the
temperature symbol will turn red and start to flash: this means that the heater is in the
heating phase.
In the case of models with bio sauna, the cloud (blue) signals that the steamer is oper-
ating; the adjustment of the relative humidity starts when the set temperature is reached
(see the "Adjusting the relative humidity" chapter).
In bio sauna mode, the steamer is turned on and off alternatively; this makes it possible
to shorten the heating times and prevent the production of steam from starting when the
temperature in the sauna is still too low.
The light in the sauna turns on automatically when the heater is turned on; it can also
be turned on and off using the relative key
Where present, you can also adjust the brightness (from 0 to 100%) by proceeding as
described below.
20:51
67%
20:51
39
(on the control panel) for a few seconds: the heater and the light
(located on the control panel).
26
20:51
26
20:51
bio sauna
5:59:14
20:51
26
100%
20:51 20:51