Warning Messages - Sony UP-20 Gebrauchsanweisung

Warning Messages

In case of a warning, only warning messages appear. The
ALARM lamp does not light.
Warning message
On the video monitor
HIT ANY KEY
INPUT MISMATCH
NO INPUT
NO IMAGE
PRINTING MEMORY
HEAD IN COOLING
66
Error/Warning Messages
On the printer window display
(only for the UP-21MD)
HIT ANY KEY
INPUT MISMATCH
NO INPUT
NO IMAGE
PLEASE WAIT
NOW PRINTING
PLEASE WAIT
HEAD IN COOLING
Possible causes and remedies
This message appears when the remote control unit is used in
CAP-STOP (CAPTURE STOP) mode and when the printer
stops capturing images once images have been captured to all
memory pages (to the last point of the last memory page).
tPress any button. Printer operation is enabled after this.
• The TV system of the signal input from the source
equipment (VTR, video camera and so on) is not
compatible with the TV system of your printer.
tCheck the signal of the TV system and input the
correct one.
tCheck the setting of the NTSC/PAL selector on the rear
panel. (See page 14)
• A signal other than a video signal (such as an audio signal,
etc.) is input.
tInput the correct video signal.
• The printer is not receiving an input signal from
equipment corresponding to the input selected on the
INPUT SETUP menu.
tCheck the input signal selected on the INPUT SETUP
menu. (See page 20.)
tCheck whether the video equipment is outputting a
video signal in playback mode.
tCheck that the connections between the signal source
equipment and the printer are secure. (See page 14.)
The image is not captured in memory.
tCapture the image in memory then start printing. (See
page 21.)
In the selected memory page, the captured image is being
printed or queued.
tRetry the operation once the printer finishes printing.
The thermal head has overheated.
tLeave the printer until the head cools down and this
message disappears. The printer starts printing
automatically.