Sony UP-20 Gebrauchsanweisung Seite 54

4
Select TEST PRINT by pressing the F or f button,
then press the EXEC button.
Nine identical images of the position selected in
step 2 are printed on a sheet of paper as a test print.
Each image has a different color balance.
Indicates the color
balance of the
images printed in the
left column. (From
the top, 45 & 45,
45 & 50, 45 & 55)
Example of the actual color change in the test print
Yellow
greenish
Greenish
Blue
greenish
5
Select the image which has the best color balance
among the nine images.
If you want to change the color balance after you
see the printout, adjust the color balance again,
referring to "To readjust the color balance" on page
54.
54
Adjusting the Color and Picture Quality
Indicates the
color balance of
Indicates the
the images
color balance of
printed in the
the images
center column.
printed in the
(From the top,
right column.
50 & 45, 50 & 50,
(From the top,
50 & 55)
55 & 45, 55 & 50,
55 & 55)
Yellowish Orangish
Standard Reddish
Bluish Red purplish
6
Display the values of BAL X and BAL Y
corresponding to the ones of the image selected in
step 5 by using the G or g button.
Example: When the color balance (55 & 45) of the
image printed on the bottom left is the best:
Display 55 for BAL X and 45 for BAL Y by
pressing the G or g button.
The color balance of the printed image has been adjusted
to the values selected in step 5.
To readjust the color balance
When the desired color balance cannot be obtained in
step 5, readjust the color balance.
You can also perform fine adjustment following the
same operation procedures.
1
Display the values of BAL X and BAL Y of the
image which is the most appropriate among nine
images.
In this case, you can perform either fine adjustment
or a rough adjustment by changing the value of
BAL STEP.