Setting The Baud Rate; Displaying The Type And Remaining Amount Of The Ink Ribbon; Registering A User Set - Sony UP-20 Gebrauchsanweisung

Setting the Baud Rate

When controlling the printer with a computer connected
to the printer's RS-232C connector, select the
appropriate baud rate. For details, contact your nearest
Sony dealer.
1
Display the SYSTEM SETUP menu from the
PRINTER SETUP menu.
2
Select the BAUD RATE item, then select the
desired baud rate by pressing the G or g button.
Baud rate (bps) Baud rate displayed on the
1200
2400
4800
9600
Displaying the Type and Remaining
Amount of the Ink Ribbon
You can always display the type of the ink ribbon and the
amount remaining on the video monitor.
Note
Use the ribbon remaining display as a criterion. The
correct amount remaining may not be displayed when
you replace the ink ribbon that has been partially used.
Also, when you load the ink ribbon and paper supplied
with the printer, the display is not correct.
1
Display the OUTPUT SETUP menu.
2
Select the RBN REMAIN item, then select whether
or not the type of ink ribbon and the amount
remaining are to be displayed on the monitor.
When you want to
Display the type of ink ribbon and the
amount remaining.
Erase the information about the ink
ribbon.
58
Making Various Settings
menu. (The display changes
from first two digit indication to
four digit indication.)
12 t 1200
24 t 2400
48 t 4800
96 t 9600
Setting
ON
OFF
Ink ribbon information
Type of ink ribbon
When the ink ribbon runs out or
is not loaded, the message "SET
RIBBON" appears.

Registering a User Set

You can store up to three settings of all the printer
specifications set or adjusted by using the buttons or the
menu, and store those settings as a user set. The printer
retains these setting - even if you turn off the power.
Thus, different operators can make printouts with
different settings by recalling the appropriate user set.
If the data of the recalled user set is modified, the printer
operates according to the modified data. In such a case,
the modified data remains effective until another user set
is recalled on the PRINTER SETUP menu, even if you
turn off the power.
After you finish all of the required settings, proceed as
follows to register them as a user set.
Note
If the user set is changed, all images stored in memory
will be cleared.
1
Display the SYSTEM SETUP menu from the
PRINTER SETUP menu.
If you want to name a user set, go to step 2.
If you do not want to name a user set, go to step 4.
2
Select the USER NAME item, then press the g
button.
The USER NAME menu appears.
Number of printouts
that can be made
with the ribbon