Error/Warning Messages - Sony UP-2800P Gebrauchsanweisung

Error/Warning Messages

Error messages
Message
On the monitor
MECHA TROUBLE: HEAD
MECHA TROUBLE: TRAY
MECHA TROUBLE: PLATEN
MECHA TROUBLE: LOAD
MECHA TROUBLE: EJECT
MECHA TROUBLE: CHUCK
CHECK RIBBON
PAPER JAMMING
SENSOR TROUBLE
END OF RIBBON
INSERT RIBBON
SET PAPER
There are two kinds of messages: error messages and warning messages. This
section lists these messages together with their possible causes and remedies. Note
the messages and act accordingly.
If a problem occurs, the ALARM lamp lights orange and an error message stating
the problem appears on the monitor and in the printer window display.
In the printer window display
MECHA TROUBLE HEAD
MECHA TROUBLE TRAY
MECHA TROUBLE PLATEN
MECHA TROUBLE
LOAD PAPER
MECHA TROUBLE
EJECT PAPER
MECHA TROUBLE CHUCK
CHECK RIBBON
PAPER JAMMING
SENSOR TROUBLE
END OF RIBBON
INSERT RIBBON
SET PAPER
Possible cause and remedies
• The ink ribbon cartridge is not loaded correctly
n Check the ink ribbon cartridge and load it correctly. (page 9)
• The paper has jammed inside the printer.
n Check the position where paper has jammed and remove any
jammed paper from the printer. (page 105)
The paper tray has got out of position.
Contact your Sony service facility or your Sony dealer to clear error
status.
The paper has jammed inside the printer.
n Check the position where paper has jammed and remove any
jammed paper from the printer. (page 105)
• The ink ribbon cartridge is defective.
n Replace the defective ink ribbon cartridge with the new one.
• The ink ribbon has torn.
n Repair the tear. (page 11)
• The ink ribbon cartridge that can not be used with this printer has
been loaded.
n Load the appropriate ink ribbon cartridge.
The paper has jammed inside the printer.
n Check the position where paper has jammed and remove any
jammed paper from the printer. (page 105)
Sensor trouble has occurred.
The printer must not be operated any further. Turn off the power
immediately and contact your Sony service facility or your Sony
dealer.
The ink ribbon has been exhausted.
Replace the old one with a new ink ribbon cartridge. (see page 9)
(The ink ribbon cannot be reused.)
The ink ribbon cartridge is not loaded.
n Load the ink ribbon cartridge. (page 9)
• Paper has been exhausted.
n Load the paper. (see page 12)
• The paper tray is not installed.
n Install the paper tray. (page 12)
Continue to next page m
Others
103