Electric Connections Table - V2 Vega-C series Bedienungsanleitung

DISPLAY DATA DESCRIPTION
FC.En End of stroke inputs
no - Input disabled (the control unit ignores it)
rALL - Inputs enabled: the door starts the slowdown phase (menu t.rAL) near the limit switches
StoP - Input enabled: the door stops near the limit switches
ASM 0.5" ÷ 2.0' Anti-skid
no - Function disabled
SEnS 0 ÷ 10 Obstacle sensor level
Cont Counter viewing
tot. - Total number of completed cycles (views in thousands or in units)
Man - Number of cycles before the next request for service (such a number has been rounded off to
hundreds and it can be set up on 1000-step; in case it is set up on 0, the request will be
disabled and no will be viewed)
APPr Automatic learning of the operation time
no - Function disabled
Go - Start up of the automatic learning procedure
FinE End of programming
no - It does not exit from the program menu
Si - It exits from the program menu by storing the setup parameters

ELECTRIC CONNECTIONS TABLE

A1
A2
J1
J2
J3
J4
J5
J6 - J7
J7 - J8
J7 - J9
B1 - B2
L
N
F1
MAINS
OVERLOAD
OP
PA
CL
36
Antenna shield
Antenna
Safety ribbons.
N.C. contact or conductive rubber ribbons
Opening control for the connection of control
devices with N.O. contact
Stop command. N.C. contact
Common (-)
Photocell. N.C. contact
Power output 24 VAC for photocells and other
accessories
Photocell TX power supply for functional test
Warning light
Courtesy light
Power phase 230VAC / 120VAC
Neutral 230VAC / 120VAC
5A (PD11) / 8A (PD11-120V)
It shows that the control unit is power supplied
It shows that there is an overload on accessories
power supply
Opening in progress
Pause (door opened)
Closing in progress
MEMO
DEFAULT
DATA
StoP
1.0"
5
tot
no
no