V2 Vega-C series Bedienungsanleitung Seite 29

Closing time
The motor will be operated for the setup time in the closing phase;
In case there is an obstacle or the end of stroke operates, the control
unit can stop the opening phase before the relevant time expires.
To avoid that the door does not close completely, we recommend to
setup a longer time than t.AP opening time.
Motor direction
The central unit is set in such a way that the motor turns in the right
direction to open and close a traditional garage door.
If the installation requires the motor's rotational direction to be
inverted, select the inv option.
Motor power
This menu allows adjusting the motor power.
The displayed value is the percentage of max. motor power.
Start off
When the door is standstill and it begins moving, the initial inertia
must be faced, therefore, if your door is quite heavy, it could not move.
In case the SPUNTO (pickup) function is activated, for the first 2
seconds of motion of each door, the control unit will ignore Pot value
and it will give motor the maximum power command in order to
overcome the door inertia.
Soft start (slowed down)
In case this function is enabled, during the first seconds of motion of
the door, the control unit will give motor a reduced power command,
for a softer start.
27