Beha-Amprobe AT-7030-EUR Bedienungsanleitung Seite 31

4. SPECIAL APPLICATIONS
Set up the AT-7000-TE Transmitter:
1. Press ON/OFF key to turn on the transmitter.
2. Press HIGH signal mode for 2 seconds to
select the CLAMP mode on the transmitter.
The clamp mode generates a boosted 6kHz
signal in order to provide superior tracing
results. The screen on the Transmitter
should appear as in Figure 4.10a.
Using AT-7000-RE Receiver
1. Press 'ON/OFF' push button to turn on the
receiver and wait for the home screen (boot
up time is around 30 seconds).
2. Select Energized TIP SENSOR mode by using the directional arrows to highlight this
operating mode and pressing the yellow "ENTER" button.
3. Hold the receiver with the Tip Sensor facing the target area.
4. Scan target area with Tip Sensor to find highest signal level. While tracing, periodically
adjust sensitivity to keep signal strength near 75. Increase or decrease sensitivity by
pressing +or – on the keypad.
5. Receiver Positioning: For best results, align groove on tip sensor with wire direction as
shown. Signal may be lost if not properly aligned. (see figure 4.10b)
6. To verify wire direction, periodically rotate receiver 90 degrees. Signal strength will be
highest when wire is aligned with Tip Sensor groove. (see figure 4.10c)
Figure 4.10b
7. PRESS ENTER when complete to return to home screen.
*Note: For best results, keep the receiver at least 1 m (3 feet) from the transmitter and its
test leads to minimize signal interference and improve wire tracing results.
Transmitter in CLAMP mode
Figure 4.10c
27
Figure 4.10a