Operation; Operation Instructions - Holzmann BT 75 Betriebsanleitung

13

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
13.1

Operation instructions

Please observe the following operating instructions so that their
work can be performed safely and has the expected success.
Check before starting work:
The sanding:
HOLZMANN MASCHINEN Austria
Perform all machine settings with the machine being
disconnected from the power supply!
 All cables and plugs
 Table and safety fence on tight fit
 The free and centered run of sanding belt and disc
 Always use the proper, located in perfect condition abrasives.
(Change wear of abrasives immediately!) With abrasive in good
condition you obtain a good grinding result.
 Do not exert too much pressure to the sanding abrasive
 Maximum distance table-sanding disc: 2mm!
 The machine has no clamp opportunity, so it is important, as the
whole area hang up the work piece on the worktable and maintain a
firm grip!
www.holzmann-maschinen.at
W A R N I N G
A T T E N T I O N
N O T I C E
OPERATION
Seite 24
BT 75