Assembly; Grinding Belt Table; Table (Disc Grinder); Dustcollector Plug - Holzmann BT 75 Betriebsanleitung

12

ASSEMBLY

Check right after receiving the machine, whether all parts according to the parts list are complete and
without damage. Each visible defect and in particular wrong amounts and transport damages must be
clearly noted on the delivery documents, otherwise the goods shall be considered as taken over and
fully accepted under the sole responsibility of the customer.
12.1

Grinding belt table

Slide the grinding belt table (2) on, above the
grinding belt and fasten it under the table with
the locking lever and the washer (3, 4).
The locking lever is pre-tensioned by a spring
and can be adjusted by pulling the grip.
Attention! To prevent fingers from being
squeezed between the band and table a
minimum separation of 2 mm has to be
maintained between the table and
grinding band.
12.2

Table (disc grinder)

Slide the grinding table (5) so the lugs fit into the
notch on the machine and press the table up
until the drilled holes match and secure it with
the locking screws and washers (6, 7) on both
sides.
Attention! To prevent fingers from being
squeezed between the band and table a
minimum separation of 2 mm has to be
maintained between the table and
grinding band
12.3

Dustcollector plug

Mount the vacuum connector (8) to the machine
using the slotted screws and washers (9, 10).
Attention! Make sure the guard reaches onto
the lower edge of the sanding table. If
the sanding table is inclined, the guard
must be adjusted for height.
HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
ASSEMBLY
Seite 23
BT 75