Operation Instructions - Holzmann ZS640P Bedienungsanleitung

14

OPERATION INSTRUCTIONS

Start the dust collector before turning on the sander.
To start the machine, press the green 'ON' button on the control box. Turn the key switch to start
the conveyor belt running. Turn the conveyor speed adjustment knob to the desired stock feeding
speed. To stop the machine, press the red 'OFF' button on the control box.
Use the crank handle to set the sanding height to the desired thickness. If the thickness is not
known, place the workpiece on the table, where under the sanding drums, and then raise the
conveyor table until the sanding drums reach the workpiece. The thickness can be read on the
depth gauge located on the front left of the machine. When feeding the workpiece, place it at the
center of the conveyor belt. There is centering gauge on the infeed side of the machine frame
that indicates the center of the conveyor belt.
The maximum workpiece thickness acceptable for this machine is 5". The minimum workpiece
thickness is 1/4". Do not attempt to sand workpieces outside of these specifications.
F
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
E
D
OPERATION INSTRUCTIONS
A Control box
A
B ON button
C Off button
D Conveyor belt key switch
B
E Conveyor belt adjustment knob
F Depth gauge
C
Zylinderschleifmaschine/ mini wide belt sander ZS640P/ZS970P
Seite 32