Herunterladen Inhalt Inhalt Diese Seite drucken

Adjustment; Grinding Belt; Grinding Belt Table; Table (Disc Grinder) - Holzmann BT 75 Betriebsanleitung

Band - tellerschleifer
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

13.2

Adjustment

13.2.1 Grinding belt

The belt has already been factory-preset. The
correct position is for it to run in the middle of
the rollers. By turning the adjustment screw,
(9), the belt can be adjusted to the left or the
right.

13.2.2 Grinding belt table

The table has an adjustment screw to fix the
table's 90° angle to the belt. Adjustment is
made as follows:
1. Release the table, with the locking lever,
and lift it as far as possible backwards.
2. Place a 90° steel setsquare on the table,
touching the other side of the belt.
3. If the angle does not equal 90°, readjust the
screw (d) with the hexagonal spanner until the
table is exactly at 90°.
4 The table can be tilted forward. Release the
locking lever, tilt the table to the desired angel
and fasten the locking lever again.

13.2.3 Table (disc grinder)

To ensure that the table is at 90° to the
grinding-plate, place a template on the table
against the plate. If a readjustment is
necessary, release the two locking screws (e)
and alter the position to 90°. Then, tighten the
two locking screws (e) again. The table can be
inclined downwards by up to 45°.
HOLZMANN MASCHINEN Austria
www.holzmann-maschinen.at
OPERATION
Seite 25
BT 75

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis