Operation; Operation Instructions; Work Table (Sanding Disc); Sanding Table - Holzmann BTS 75-2 Betriebsanleitung

13

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
13.1

Operation instructions

Perform all machine settings with the machine being
disconnected from the power supply!
 Never Start the machine while pressing the workpiece against the
abrasives!
Check table and safety stops on tight fit

Always use the proper, located in perfect condition abrasives.

Guide the workpiece always on the matching stop

13.2 Operation

13.2.1 Work table (sanding disc)

Loosen lock lever (1).
Set desired angle.
Retighten lock lever (1).
Loosen stop lock lever (2).
Set desired position.
Retighten stop lock lever (2)

13.2.2 Sanding table

To use the sanding table open the
sanding table cover

13.2.3 Switches

ON-OFF-switch:
Press green button (I): turn on
Press red button (0): turn off
2-step-switch:
Step 1: 11m/s
Step 2: 22m/s
HOLZMANN MASCHINEN GmbH
W A R N I N G
www.holzmann-maschinen.at
N O T E
OPERATION
22
BTS 75-2