Changing Grinding Belt; Changing Grinding Disc; Storage; Cleaning - Holzmann BT 75 Betriebsanleitung

14.2

Changing grinding belt

1. Loosen the locking screw (a) on the upper
cover (e).
2. Loosen the crosshead screws (b) holding
the lateral cover. Fold the lateral cover and
raise it (two pins of the machine rack).
3. Release the guiding button on the belt (c).
Remove the grinding belt (d) from the three
rollers.
4. Install a new band and replace the cover
(e) on. Tighten the screws again.
Make sure the belt is running centrally. If
necessary, adjust it with the grinding belt
adjustment screw.
14.3

Changing grinding disc

If the grinding disc (e) is worn, pull it off the
grindingplate. (Velcro® fastening)
Place the new disc on the centre and push it
on to the grinding plate.
Remove the grinding disc if it does not run
circularly. Readjust it.
14.4

Storage

 Tension the sanding belt of the belt sander.
 Store the machine in a dry and well ventilated place.
14.5

Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.6

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old.
HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
N O T I C E
MAINTENANCE
Seite 28
BT 75