Parameterizing By Loading Parameter Files (Download P060 = 6) - Siemens simovert masterdrives Betriebsanleitung

04.2006
9.2.3

Parameterizing by loading parameter files (download P060 = 6)

Download
Fault
Run
I
O P
USS-Bus
Jog 7 8 9
4 5 6
1 2 3
0 +/- Reset
OP1S
Laptop
Automation unit
(e. g. SIMATIC S7)
Siemens AG 6SE7087-6KD60
SIMOVERT MASTERDRIVES
When parameterizing with download, the parameter values stored in a
master unit are transferred to the unit to be parameterized via a serial
interface. The following can serve as master units:
1. OP1S operator control panel
2. PCs with DriveMonitor service program
3. Automation units (e.g. SIMATIC)
The interface SCom1 or SCom2 with USS protocol of the basic unit and
field bus interfaces used for parameter transfer (e.g. CBP for
PROFIBUS DP) can serve as serial interfaces.
Using download, all changeable parameters can be set to new values.
Operating mode Type of construction
Individual operation Compact, chassis
Bus operation Compact, chassis
Operating mode Type of construction
Individual operation Compact, chassis
Operating mode Type of construction
Bus operation Optional board CBx
e. g. CBP for Profibus
Fig. 9-4 Parameter transfer from various sources by download
Operating Instructions
Terminal
X300
(SCom1)
X101
USS via RS232
Terminal
X300
(SCom1)
Terminal
e. g. X448
for CBP
Parameterizing Steps
SIEMENS
X300
9-39