Siemens simovert masterdrives Betriebsanleitung Seite 260

Connecting-up
X102 – Control
terminal strip
X103 – Pulse
encoder connection
7-14
The following connections are provided on the control terminal strip:
♦ 10 V aux. voltage (max. 5 mA) for the supply of an external
potentiometer
♦ 2 analog inputs, can be used as current or voltage input
♦ 2 analog outputs, can be used as current or voltage output
Terminal Designation
13 P10 V
14 N10 V
15 AI1+
16 M AI1
17 AI2+
18 M AI2
19 AO1
20 M AO1
21 AO2
22 M AO2
Connectable cross-section: 0.14 mm² to 1.5 mm² (AWG 16)
Terminal 13 is at the top when installed.
Table 7-6 Control terminal strip X102
The connection for a pulse encoder (HTL unipolar) is provided on the
control terminal strip.
Terminal Designation
23 - V SS
24 Track A
25 Track B
26 Zero pulse
27 CTRL
28 + V SS
29 + Temp
30 - Temp
Connectable cross-section: 0.14 mm² to 1.5 mm² (AWG 16)
Terminal 23 is at the top when installed.
Table 7-7 Control terminal strip X103
Meaning
+10 V supply for ext.
potentiometer
-10 V supply for ext.
potentiometer
Analog input 1 +
Ground, analog input 1
Analog input 2 +
Ground, analog input 2
Analog output 1
Ground, analog output 1
Analog output 2
Ground, analog output 2
Meaning
Ground for power supply
Connection for track A
Connection for track B
Connection for zero pulse
Connection for control track
Power supply pulse
encoder
Plus (+) connection
KTY84/PTC
Minus (-) connection
KTY84/PTC
6SE7087-6KD60
Operating Instructions
04.2008
Range
+10 V ± 1.3 %,
Imax = 5 mA
-10 V ± 1.3 %,
Imax = 5 mA
11 bit + sign
Voltage:
Ω
± 10 V / Ri = 60 k
Current: Rin = 250
10 bit + sign
Voltage:
± 10 V / Imax = 5 mA
Current: 0...20 mA
Ω
R ≥ 500
Range
HTL unipolar;
L ≤ 3 V, H ≥ 8 V
15 V
Imax = 190 mA
KTY84: 0...200 °C
PTC: R cold ≤ 1.5 k Ω
Siemens AG
SIMOVERT MASTERDRIVES
Ω