Siemens simovert masterdrives Betriebsanleitung Seite 356

Parameterizing Steps
Only deviations from the standard setting (P114 = 0) are indicated:
P114 = 0
0ms (n-ctrl.)
P216=Smooth n/f(FWD)
4ms (f-ctrl.)
P217=Slip Fail Corr'n.
4ms (n-ctrl.)
P223=Smooth n/f(act)
0ms (f-ctrl.)
P235=n/f-Reg Gain1 3.0 or 5.0
P236=n/f-Reg Gain2 3.0 or 5.0
6*P357 (T0)
P273=Smooth Isq(set)
P240=n/f-Reg Tn
P279=Torque (dynamic)
P287=Smooth Vd(act)
P291=FSetp Flux(set)
100%=off
P295=Efficiency Optim.
10-20ms
P303=Smooth Flux(set)
P315=EMF Reg Gain
P339=ModSystRelease 0=All syst 3=only RZM 3=only RZM 3=only RZM 3=only RZM
P344=ModDepthHeadrm
P536=n/f RegDyn(set)
9-66
P114 = 1 P114 = 2
4.8ms
(n-ctrl.)
0=off 2=on (n-ctrl)
100ms
400ms
20.0%
9
100%
99.9%
60ms
Gain(n) 1.5*Gain(n)
(f-ctrl.)
0.0% 3.0% 3.0%
50% 20% 100 (n-ctrl.)
50% (f-ctrl.)
RZM = Space vector modulation
The gain Kp of the speed controller (P235, P236) depends on the
inertia of the drive and has to be adapted if necessary.
Symmetrical optimum:
The start-up time is the time taken by the drive to accelerate to rated
speed when the rated torque is specified. This is determined during
automatic speed controller optimization.
P114 = 3 P114 = 4
12.0 (n-ctrl.)
12.0 (n-ctrl.)
40ms (n-ctrl.)
0 0
1.5*Gain(n)
(f-ctrl.)
200 (n-ctrl.) 200 (n-ctrl.)
100 (f-ctrl.) 50% (f-ctrl.)
P235 = 2 x P116 / P240
Kp = 2 x T
start-up / Tn
Operating Instructions
04.2006
P114 = 5 P114 = 6
80% (f-ctrl.)
110%
50%
100 (n-ctrl.)
500 (f-ctrl.)
25% 100 (n-ctrl.) 100% (n-ctrl.)
50% (f-ctrl.)
6SE7087-6KD60 Siemens AG
SIMOVERT MASTERDRIVES
P114 = 7
2=on
3*P357
3=only RZM
30.0%