Cleaning And Disinfection - Dräger X-plore 6300 Gebrauchsanweisung

Cleaning and Disinfection

Clean and disinfect the mask after every use.
WARNING!
Only use the approved cleaning products and
disinfectants listed below. High doses and long
exposure times can damage the mask.
Cleaning
Clean the mask after every use so that it will be ready for use by
another person. Should the mask by used exclusively by one person
the cleaning intervals can be limited to keeping the mask in a hygienic
condition.
Breathing protection equipment used by more than one employee
must be cleaned before being handed on to the next person.
Do not use solvents, such as acetone, alcohol, etc. to clean the mask.
WARNING!
The mask body must be thoroughly cleaned to
ensure that no residual skin-care products remain
on the mask body.
Otherwise the sealing will lose its elasticity and the
mask will no longer provide a snug fit. This can
cause danger of poisoning!
• Add some all-purpose cleaner such as Sekusept to lukewarm
1)
water , then use the liquid and a cloth to clean.
• Rinse thoroughly under running water.
1) Note the corresponding Instructions for Use.
18
Disinfection
Disinfect the mask after every use to maintain a hygienic condition. It
is the sole responsibility of the user to ensure that the mask is com-
pletely free of pollutants after every treatment.
• Immerse the mask in the disinfectant.
1)
Use Incidur disinfecting agent.
• Rinse thoroughly under running water.
Machine cleaning and disinfection with Eltra
Observe Instructions for Use 90 21 380.
Drying
• Leave the mask to dry in a drying cabinet or in air.
o
Maximum temperature 60 C.
Keep away from direct sunlight.