Mounting the Anti-tipper
Abb.1
Abb. 3
Mount the receiver tube with the two screws (Fig. 1, item 1) on the inner side of
the posterior frame part. Tighten the nuts (Fig. 1, item 2) with a torque of 9 Nm.
Insert the expansion spring (Fig. 2, item 4) with the close eyelet into the receiver
tube. When the receiver tube's bore hole and the eyelet hole are flush, insert the
sleeve (Fig. 2, item ). Secure the sleeve with the screw (Fig. , item 7). Tighten
the nut (Fig. , item 8) with a torque of 7 Nm.
Hook a cord (Fig. , item 10) into the lower eyelet of the expansion spring and
push the anti-tipper tube (Fig. 2, item 6) over the cord and expansion spring into
the receiver tube.
Pull at the cord (Fig. , item 10) until the expansion spring extends from the anti-
tipper tube (Fig. 2, item 6).
Secure the expansion spring using a screwdriver (Fig. 4, item 11) and remove the
cord. Put the spring holder (Fig. 4, item 12) onto the lower eyelet of the expansion
spring. Remove the screwdriver and the eyelet of the expansion spring will lock in
place.
80
I
Abb. 2
III
Abb. 4
II
IV