Addressing The Devices; Operation; Select Color-Mode; Internal Programs-Mode - EuroLite IR2DMX Bedienungsanleitung

5.4 Addressing the devices

The devices to be controlled need to be assigned the DMX starting address The starting address is defined
as the first channel from which the devices will respond to the controller.
Please assign the starting address to the devices as follows:
001 - LED PARCAN 1
006 - LED PARCAN 2
011 - LED PARCAN 3
016 - LED PARCAN 4
021 - LED KLS-200 RGB, also KLS-400/800/401/801/1001
036 - LED Bar RGB 252/10
Now you can start operating them via your DMX LED Operator IR2DMX.

6. OPERATION

Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
After you connected the device to the mains, the DMX LED Operator IR2DMX is ready for use.
The LED-effects are controlled via the optional 51914130 EUROLITE IR remote for LED effects.
Direct the remote control towards the front of the IR sensor. The maxium operating range is 10 meters.
6.1 Color Select-Mode
In the Color Select-Mode, you can call up the individual colors manually via the buttons R, G, B.
Select the desired colour intensity via the +/- buttons.
Press the button of the desired color.

6.2 Internal Programs-Mode

In the Internal Programs-Mode, you can call up the internal programs.
Press the PROG SELECT-button.
Select the desired program via the +/- buttons.
Select the desired speed via the SP and +/- buttons.
Select the desired Flash-Frequency via the F and +/- buttons.

6.3 Auto-Mode

In the Auto-Mode, you can call up the auto program as an endless loop.
14/15 00058530.DOC, Version 1.2