Connection Of The Devices - EuroLite LED LMCT TUBE 144 RGB Bedienungsanleitung

The device must be installed in an absolutely horizontal position.
Always install the device via all fixation holes.
Do only use appropriate screws and make sure that the screws are properly connected with the ground.
Procedure:
Step 1: The LED tube has 2 baseplates, with 1 hole each for the installation.
Step 2: Hold the baseplate onto the location where the device is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes and screw the screws in until they are almost plane with the mounting surface.
Step 5: Hold the baseplate in the desired position and mount the LED tube.
Before taking into operation for the first time, the installation has to be approved by an expert!
Caution: A maximum of 8 LED tubes may be used without a booster.

Connection of the devices

P1 = 2-pin socket
P2 = 2-pin plug
P3 = 120 . termination plug (end piece)
Attention: The power supply must be interrupted between P1 and P2 every four tubes before and after the
booster. A booster must be installed after every eight LED tubes for signal enforcement and new power
supply.
OPERATION
Connect the fixture to the mains with the power-plug of the EUROLITE LED LMCTC RGB DMX controller.
DANGER TO LIFE!
11/12 00027018.DOC, Vesion 2.1